crystal disk mark output sandisk ultra 200 gb

AS SSD BenchmarkĪS SSD is a solid benchmark that does not write compressible data to drives. SanDisk 406s (lb406s) 400GB SLC SAS SSD Quick Benchmarksįor our quick tests during this part of the series we will just provide the quick benchmarks with only a bit of commentary. It also is a reason NVMe is going to be a game changer in the enterprise storage space.Ĭontroller wise, the LSI SAS 2008 controller has plenty of headroom for this configuration. There is a latency penalty for going over the PCIe bus to a controller to SAS. This means that one cannot compare results directly to consumer-driven setups where a SATA SSD is connected to an Intel PCH port. A major point here is that we are using a SAS controller. For those looking to build value SAS SSD enabled arrays, the LSI SAS2008 is likely going to be the go-to controller.

We decided to use this controller since it is an extremely popular first-generation 6gbps SAS II controller. We did not use our Intel Xeon E5-2600 V3 platforms because this series started prior to the embargo being lifted on that platform. The Gigabyte’s LSI controller found onboard is the same as can be found in countless platforms and cards such as the IBM ServeRAID M1015 and LSI 9211-8i.

SAS Controller: (onboard LSI SAS2008 in IR mode).

Processors: Dual Intel Xeon E5-2690 (V2).Since we are going to assume the use of already released hardware, we are using a legacy system for testing across the test suite: Each of those articles linked above has additional detail about the drives being tested. Smart Storage System/ SanDisk Optimus 400GB MLC SAS SSD benchmarks.Seagate Pulsar.2 200GB MLC SAS SSD benchmarks.Pliant/ SanDisk Lightning 206s 200GB SLC SAS SSD benchmarks.We are using the same test configuration and benchmarks in our initial figures just to provide some consistency here.įor those keeping track, here are the pieces thus far in the series: The big question we have is how do these SanDisk Lightning 206s drives handle read and write scenarios where data is striped across both disks simultaneously. Most SSD reviews are based on single drives so we decided to try something slightly different: RAID 0 benchmarks with two drives. We were using our “quick and dirty” suite of three benchmarks to test a few SAS SSDs we picked up for under $0.60/ GB. While these are certainly not the full suite, they do give at least a quick level of performance.

We recently provided some figures from our initial benchmarking on a single Pliant/ SanDisk Lightning 200GB SLC SAS SSD.

Crystal disk mark output sandisk ultra 200 gb